(Above - Closed up and ready for trimming)
(Above - Trimmed, ready for bindings)
I had minor issue with tear out on the soundboar lower bout. Actually it was really just a split and all that was required was a small drop of glue and small bit of tape to glue it back into place (you can see the tape in the photo).
After trimming the guitar I noticed that the base of the guitar curves in ever so slightly where it joint is on both sides. Im guess this is beause I didnt radius the end block and have forced the curved ribs onto the flat end block leaving the humps. Another lessons learnt.
Next up is the bindings and im still deciding on whether to do it by hand using a purfling cutter and chisels or use the router. If I use the router Ill have to purchase a bearing set and make a jig for the router.
Im also having troubles working out what bindings and purflings to use as I have a few that I have purchased:
Bindings: Black (plastic), Maple w/ BWB
Purfling: BW (Plastic) and chequered (wood)
I think the decision will be easier once I have cut the binding channels so I can see how each combination looks.
No comments:
Post a Comment